DIGIT-ARC read-only archive · snapshot: July 23, 2026
T
theterminator Original post #1
Jun 28, 2013 at 9:20 AM
how much backup will i get from 600VA, 700VA, 800VA , 1000VA UPS' ?? I am purchasing a computer & i need some backup since I will be doing work & there is frequent power cut here.

Display: 19" led, ~3k graphics card
saswat23
Jun 28, 2013 at 10:15 AM
That depends on your PC specs.
But generally:
600VA gives around 12 mins
800VA gives around 20 mins
1KVA gives around 40-45 mins
Chaitanya
Jun 28, 2013 at 10:28 AM
It mainly depends on your battery..
baiju
baiju #4
Jun 28, 2013 at 12:26 PM
Backup depends on the battery capacity. Go for UPS with external battery.
avinandan012
Jun 28, 2013 at 3:26 PM
@op please post full PC configuration.
a PC with typical load of around 180W-200W the APC1100VA(660W) will give about around 20mins.

PC load depends on PSU quality. Same config with a platinum grade PSU will give more backup time than a bronze one.

Then there is efficiency of the UPS itself. Look closely most PSU efficiency ratings are at 50% load.

I would say if you have money go for those home UPSs with those heavy batteries 800VA with 200Ah will be around 12-13K.
And if you want professional grade backup contact APC. 1500VA + batteries for 800W load for 4hrs costs around Rs. 20K+ and you get APC onsite warranty.
These(1500VA and above) are ready for continuous operation without environment control.

Cause the output transistors of lower W models are not intended to run long times at load like 1hr or more. Server grade UPSs with extra battery packs costs higher cause they use high grade(W and temperature) output transistors.
harshilsharma63
Jun 29, 2013 at 9:09 AM
It not just about the backup time, the UPS should be able to deliver enough wattage for the pc and for this, you need to mention the full config.
Chaitanya
Jun 29, 2013 at 12:38 PM
Cause the output transistors of lower W models are not intended to run long times at load like 1hr or more. Server grade UPSs with extra battery packs costs higher cause they use high grade(W and temperature) output transistors.

Hmmm...
Never thought about that, good point