Edited post to embed the video.
Don't try this, will damage u board. If some one like to try it try on ur old board.
but the mobo still works fine
Is this supposed to be a joke? If it is, it's not funny. If some people took it seriously, they are likely to damage their motherboards permanently.
That's an oooold motherboard, probably from the Pentium 1 era. ISA slots, for heaven's sake. Heck, the guy doesn't even know how to remove a BIOS battery properly.
Any liquid on a finished electronics product, especially something as sensitive as a CMOS-based motherboard, is potentially disastrous. It may not cause damage IF it is perfectly dried out quickly, but getting it completely dry again is not as easy as you may think.
Blowing on it with a hair dryer for a few seconds will NOT do the job. There are hundreds of tiny spaces where water will remain unless the motherboard is left in a heated vacuum chamber, or out in the sun for days. It will cause corrosion and short circuits.
The person who posted it on YouTube probably meant it to be funny. But posting it here without a clear warning is in bad taste.
Also if small dust enter the SOCKET the processor performance will be down !!
That is a joke. And who said that performance will go down if dust enters the socket????
^^^ the guy who clean the motherboard inside the water !!
In the video they never show that the board is in the working condition in the starting and end
@damngoodman999, when the socket is sealed shut (while processor is docked), how can dust go in? That guy is an idiot. The only way to clean motherboard is by using air blower (not hot air blower) and couple of brushes. There are certain chemicals (like oxidizers to clear rust etc) that can be used to clean motherboard but you won't find it available in the market.
Shouldn't this thread be in Tutorial Section?
MODS plz look into the matter
^^ nice joke there Aspire.