Cooling VRM · DIGIT-ARC

I installed a fan with support from ties tied to various parts :))

*i.imgur.com/g8pur.jpg
*i.imgur.com/wESOk.jpg
*i.imgur.com/2tofX.jpg

Any improvement on performance?

this is just to decrease vrm temperature skud.

OK, got it. I thought you are going to bump the speed and volts.

Nice innovation.

thanks buddy

nice - you can put another 80mm fan on the top side from inside ;-)

T

i did that to my 78LMT-S2P tooo

^nice!

@TP
yes, i will be adding fans.

topgear said:
nice - you can put another 80mm fan on the top side from inside

this is what should be done. though cooling will less but at least safer.

@jassy, innovative buddy but check those wire ties. if any of those gets loose, you'll get a processor biriyani :mrgreen:

^^ just remove the air filter from the top side - and the fan will dissipate lots of hot air and keep the system cooool ;-)

or you can build a heat sink with aluminium(get 1meter of those window rail aluminium sockets ), it's not that difficult .
just measure the VRMs as a whole

Sam said:
this is what should be done. though cooling will less but at least safer.

@jassy, innovative buddy but check those wire ties. if any of those gets loose, you'll get a processor biriyani

i have tied it securely. :))

avinandan012 said:
or you can build a heat sink with aluminium(get 1meter of those window rail aluminium sockets ), it's not that difficult .
just measure the VRMs as a whole

how to stick it? with TIM?

but i read somewhere cooling with fan is better.