How 2 connect 2 lappy with one dataone connection(H500)..

M

plz help/ /i am in 1st floor// my frnd in 3rd floor.. i am taking Dataone BB.. and my frnd want 2 share.. .how 2 do it.. and what will be d cost..???

nd we both want 2 access net at d same time...

see this: *www.thinkdigit.com/forum/showthread.php?t=54225&highlight=dataone

get a wifi router, and two wifi usb or pci cards. and follow the guide here

Cost will be approx 4.5K (wifi router + 2 PCI/USB wifi cards)

Cheap solution.. Get a normal 4 port switch, connect modem to router , one connection from router goes your PC other to your friends PC..

1000-1500 depending on the switch cost.

in both cases you need to configure the network properties..

M

what is d cost of router???

so basically i hav 2 buy a port switch.. nd router.. .. is there any other cheap solution/// i dont want 2 spend more on this setup...

Wi-Fi router is around 2.5K

M

that price is way 2 much.. suppose if i buy Type III modem with 4 ethernet ports them cant i take 2 connection from those ports nd connect it 2 2 laptops??
plz provide very cheap soln..

yes ofcourse.. but its not wireless and you cant move around..

M

wireless is not required.. so.. jst the modem and 2 wires 2 2 laptop.. this will do.. right?? nd one more thng. suppose we both connct at same time.. spedd will be shared or same 2mps for both .??

^^^ The speed will be shared.

Yes.. you can see as 2 Mbps.. but the speed will be shared as charan said

taking two dataone H250 connxns seems more viable for you both.unless you need NU which H500 provides.

M

actually.. night unlmited is required...

Hijacking the thread lil bit (as usual

)

The Connection is SU (Single User) type isn't it ? Still we ca share it using router ? I know using a proxy it is ok, but possible using a router ?

Sorry, I am totally ignorant in this, thats why the question.

he he din .. ofcourse we can share

check this thread by choto *www.thinkdigit.com/forum/showthread.php?t=54225

Charan said:
he he din .. ofcourse we can share

check this thread by choto *www.intel.com/products/motherboard/DP35DP/index.htm

I think you are very sleepy

Or weekend hangover ? LOL, just kidding, don't get mad !!

But what you posted is - Intel® Desktop Board DP35DP - That is not by Choto too

I know its a mistake .. j/k .. anyway what is the correct link ?

lol .. one should not post replies while watching TV

here is the correct link
*www.thinkdigit.com/forum/showthread.php?t=54225

LOL, np

Thank you very much for the link

Offtopic:

Other link you sent, USB ports - 12 numbers !! WOW

S

do one thing type 192.168.1.1 in your IE this will open the modem conifg page.
Now in WAN Setting make it ppp0e type and type your user name and password.

now connect that modem directly to the switch you will purchase.

and connect your two laptops directly to the switches. Wallah your connection is ready and running.

do not forget to type the ip address as follows in your laptops both of them

First laptop

ip 192.168.1.100
subnet 255.255.255.0
gateway 192.168.1.1

DNS 192.168.1.1

Second Laptop

ip 192.168.1.101
subnet 255.255.255.0
gateway 192.168.1.1

DNS 192.168.1.1

M

the above procedure seems 2 be the easiest one..(price of switch??) now .. plz tell how 2 conncetc lappy nd laptop...??

Price of 8 Port TechCom Switch is about 500 Rs...

What u need:

Few Meters of LAN Cable.

4 RJ-45 Pins (5 Rs Each)

If u purchase 4 meters of LAN cable, then cut the cable to 2 meters. And Get the cables crimpped with "Cross-Over" Type (20 Rs For Crimpping)

Plug the RJ-45 cable that comes from router to Port 1

Then Plug the Cable 1 to one end of the Laptop and the other end to Port 2 of the Switch.
Then Plug the Cable 2 to one end of the laptop and the other end to port 3 of the switch.

Now All the physical setup is complete.

Turn On the Switch, Router and both the Laptops.

No you should see a ballon that says "Network Connected"

In both laptops, follow these steps:

Start>All Programs>Communications>New Connection Wizard>

Click Next, Then Select "Small Office or Home Network".. Then press finish.

Now the "Network Setup Wizard" will start, click next and again next... select the LAN adapter.. and click next..

Give The same workspace name for both..

Here you will get so many options..

Select "This Computer connects to Hub which is connected to Internet" or something like that.. (i forgot)

Perform this in both the Laptops..

It will assign a automatic IPs..

You can change it if u wish.. in the Network Connection Properties..

Like 192.168.10.1 for laptop 1 and 192.168.10.2 to laptop 2

Give the subnet mask to both the laptops as 255.255.255.0

follow the instructions given by s151157, to share the internet settings..

M

in the above post u r taking about router.. but i dnt have one.. i i dont want 2 but router.. nd rearding switch wht is the minimum i hav 2 pay??

Hmm.. so did i waste my 20 minutes?

@Gigacore

No, you didn't waste your time at all

Sure it will help some others.

^ Well.. Lets see....

M

@gigacore.. dint try 2 hurt u... sum one else will benefit//

^ na.. i didnt get hurt.. why should i

never mind, it helps others

M

i hav connected a ethernet cable between lappy nd desktop( ethernet port).. now how to share files between them...?????

How to configure file sharing in Windows XP

M

could someone xplain it in a simple way/.. plzzzz

plz help....

Chesk these

Windows XP Sharing files

Sharing Disks and Folders on Windows XP

How to Share and Set Permissions for Folders and Files Using Windows XP

Lil googling always helps