Guys,
My system runs at AI overclocking set in the BIOS, so my E8400 runs at 2.4 GHz instead of 3 GHz. When I set the overclocking to default (333), sometimes my monitor goes into standby when the system restarts, i.e. I suspect there is no signal from the video card. However the system responds to Ctrl+Alt+Del.
After numerous resets, the system starts but, it is running at 2.4 Ghz and a message at the bottom says "Overclocking failed".
However, after running for some time, it runs well, even after overclocking to default.
Sometimes, when I start the system after a long time, the monitor still goes into stand by irrespective of whether the processor has been overclocked or not.
My system runs at AI overclocking set in the BIOS, so my E8400 runs at 2.4 GHz instead of 3 GHz. When I set the overclocking to default (333), sometimes my monitor goes into standby when the system restarts, i.e. I suspect there is no signal from the video card. However the system responds to Ctrl+Alt+Del.
After numerous resets, the system starts but, it is running at 2.4 Ghz and a message at the bottom says "Overclocking failed".
However, after running for some time, it runs well, even after overclocking to default.
Sometimes, when I start the system after a long time, the monitor still goes into stand by irrespective of whether the processor has been overclocked or not.
