i have PI845GLM-P and nVIDIA AGP GeForce FX 5200 128MB graphic card. when i insert the card in agp slot, the fan start spinning but didnt gve output to the monitor. and when i connect the monitor cable to onboard graphic, my windows XP pro didnt show any "NEW HARDWARE FOUND" either. but the card work fine in 2 of my friends system. motherbaord is brand new. and i have 350W of smps. plz help me.........
Post ur full system config
first uninstall the driver of ur onboard video then go to BIOS and disable onboard graphics and set AGP as the default graphics and u r done
1st check whether Ur mobo supports agp card coz some 845 motherboards
have some kind of warning labled on their agp slot not to use a graphics
card. If Ur mobo has nothing like that then follow these steps:
Uninstall the onboard graphics driver
POWER DOWN THE COMPUTER
1.Remove the AGP card & clean the AGP slot
2.Insert the agp card into the slot
3.Clear your mobos CMOS settings(ie bios settings) by jumper
>-<))))) See Ur mobos manual for Step No.3 & 4 ((((((>-<
4.Sit the jumper caps in the right place
5.Now start Ur Comp, Now it should boot & give U display
I have a Mercury PI845GLM-AGP board with 5200 Gfx card(AGP)
When i insert this Gfx card it gave me the same prob & I solved it
by the above steps.
the manual shows that it support AGP card. i cleared the bios, disabled onbaord graphic and even clean the AGP slot. still i cannot get any display. i insert my friends ATI graphc crd ( i dnt know tha model), and that one also dnt gve any display
Then Ur mobo has some problem
try a higher (400 or 500w) power supply from any of ur friends
are u connecting ur monitor to the onboard port or to that of the card??
i connect to onboard, it give display.......connect to graphic card, it dont give display........
First set the " unit display first" in bios to AGP from PCI. Then try again.
there is no AGP on "UNIT DISPLAY SYSTEM". Only PCI and ONBOARD. When i select PCI it give output to onboard not on the card
