S sandeep410 Original post #1 Dec 7, 2011 at 11:11 PM My hard dsik doesnt gets detected 40% of time.when it does gets detected after sometime after logging in it just vanishes.Especially when i am doing something on that hard disk.i ran a smart test and it says ok?
0 008Rohit #2 Dec 7, 2011 at 11:40 PM Check if the Hard Disk power connector and SATA connector is properly connected.
clmlbx #3 Dec 8, 2011 at 12:35 AM check sata/pata and power cables.. check if jumper are in proper place.. check for bad sectors.. pls share specs of your rig .
W whitestar_999 #4 Dec 8, 2011 at 1:25 AM if S.M.A.R.T values are ok then it is most likely a power/connector related problem.
S sandeep410 #6 Dec 8, 2011 at 2:28 PM I already tried switching but problem still persits 2 out of 4 hard disk has the problem
S sandeep410 #8 Dec 8, 2011 at 4:24 PM avichandana20000 said: if possible use that HDD in another system. Click to expand... That aint possible any other ideas
coderunknown #9 Dec 8, 2011 at 6:14 PM is it a pata HDD? check with a new cable. happens usually when cable is badly twisted.
topgear #13 Dec 9, 2011 at 5:30 AM ^^ check the SMART status of those HDDs - use HDTune pro or your HDD manufacturers official diagnostic tool for that.
lywyre #14 Dec 9, 2011 at 9:04 AM Make sure your hard disk is fixed firmly. Loose cable (power or data) is the most likely cause. Also try a different SATA port on the mother board.