no display · DIGIT-ARC

hi,
i plugged all the connecting cables to clean ma pc hardware
n after plugging i not able to gwt any display on the screeen n also i restarted after unplugging ram theres no beep but cpu n graphic are workin as normal. please help :sad:

Please put in your case in a detailed and proper manner plus do mention your PC's configuration then after someone can try to help you out.

P

prabhu.wali said:
hi,
i plugged all the connecting cables to clean ma pc hardware

Do you mean that you UNplugged everything?

n after plugging i not able to gwt any display on the screeen

Do you mean that you reconnected everything?

n also i restarted after unplugging ram theres no beep but cpu n graphic are workin as normal. please help

If you're not getting any display, how can you say that your CPU and graphics card are working? Do you mean that the fans are spinning? Spinning fans don't necessarily mean that the devices are working.

It's very likely that there's something you did not reconnect properly. Carefully check all connections, make sure they all fit firmly. It will be better to pull them out and then re-insert them again firmly. Then try again.

It will be best to leave the hard disk unconnected until you get a proper display again.

Your CPU is overheating.
Make sure you have installed heatsink properly and is in good condition(i.e. no broken screws etc.).Also buy Heatsink paste in a computer store to apply on CPU surface and heatsink bottom.

i've connected all cables properly n there is no beeping sound after unplugged the ram modules