I was trying to set up my repeater for my dlink router.After setting up repeater from tendas router page im not able to access it.running ifconfig the default gateway is blank.Before it was 192.168.0.1.Any help?
Not able to access routers web page.
Have you tried 192.168.1.2 ?
Some routers allow you to specify the IP while you configure it. Did you set anything with that ? What was the default IP ?
Some routers allow you to specify the IP while you configure it. Did you set anything with that ? What was the default IP ?
Are you using a router as a repeater ? What is the make and model no of the device ?
If the IP I gave does not work, the only way is to reset and look for the default IP which is set for Tenda.
Aftet resetting im able to access the IP but after setting up repeter again im not able to load the router page.The defaulf gateway goes blank.
Sent from my SM-G955F using Tapatalk
W
You can not access 2nd device setting page if it is provided IP by a primary device within its own DHCP range.e.g.assuming your dlink & tenda routers both have 192.168.0.1 as their home IP then you can not access tenda when primary device in wifi network is dlink.Also in case of repeaters it is usually the case that repeater IP is decided by primary router which again makes accessing repeater settings page not possible depending on repeater default home IP.
Tendas ip is 192.168.0.1 and dlinks is 192.168.1.1
So if i want to access repeater then what should i do?
Is resetting router too many times okay4
?
Sent from my SM-G955F using Tapatalk
W
In Tenda repeater settings disable DHCP & manually assign IP 192.168.0.2 to Tenda repeater(note it is different from "home ip" of tenda which is 192.168.0.1). Resetting router is ok but why reset when you can simply change the settings,reset is usually done in case of lost or forgotten password.