Pc couldn't boot up · DIGIT-ARC

Now again a new issue my pc is not booting it just reached verifying DMI pool Data screen nd cursor keeps blinking what could be the reason ....plzz help

Plzz help how can I solve it.... very much frustrated.....plzz help

Sandeep dubey said:
Plzz help how can I solve it.... very much frustrated.....plzz help

Can you post a screen shot?

This is the Ss I have even tried system restore but it's showing no error its showing its maybe Becoz I have connected some new device boot again it will start... but it's still stucked at this screen

Also I have tried cmd option I have run commands fixboot fixmbr etc...but still no resolution...

I have just bought a new hard drive so I don't this it's because of hard disk as I have checked all working fine with no error by chkdsk

Plzz help I m totally blank .... yea as I have just installed a new os and after mounting the unallocated space and after installing driver this is occurring

Is this Becoz of new mounting of unallocated space..... I don't know what to do plzzz help should I go for installing a core os again ??.......plzzzzz Sunil help ......

W

Why are you using your primary hdd in slave mode that too on IDE channel 1?It is recommended to use primary IDE hdd in master mode to avoid many potential issues.
How to Set Jumpers for Your Computer’s IDE Drive - dummies

White star .....what you think is it because of slave connection???... I'll connect it in primary slot...

Plzz help me solve this problem......

whitestar_999 said:
Why are you using your primary hdd in slave mode that too on IDE channel 1?It is recommended to use primary IDE hdd in master mode to avoid many potential issues.
How to Set Jumpers for Your Computer’s IDE Drive - dummies

plzz help

W

It is not primary slot,there is a jumper setting on hdd by which one can put an IDE hdd in master or slave mode.Did you read the link I posted earlier,just follow the instructions in that link.

Ok...