Hi, I was using graphic card for my display. Today I gave my graphic card for replacement because fan was making noise. So removed my card n gave to service center. Bt before the I forgot to change the settings in cmos setup, my onboard graphics were disabled. So now I can't see any display on my monitor via onboard graphics. I removed motherboards battery n put it Again thought I would reset the settings but no use. Is there any other way? My graphic card is coming after 15 days.. N without p, wt will I do.!
do you get absolutely no display or does it atleast show the bootscreen/the mobo logo flash screen etc before it goes blank?
No display
Even I connected to hdmi bt same.
Change the Jumper settings on motherboard.
It will bring the BIOS to default set.
Oh, it's difficult for me. I don't know the settings
Post your motherboard Model # . So that we can show you a pic of where the jumper will be.
Btw , you can also lookup into the Manual for your motherboard at the manufacturer site.
Gigabyte ma785gmt ud2h. I didn't find it in manual.
In the manual , look at the motherboard layout on page 7.
There you will find CLR_CMOS beside PCIe connector.
That is where you need to change the jumper setting.
For further details see youtube videos , it will make it easier for you.
Did jumper thing n it worked. Thanks
Thanxx a lot mate , u saved me !!
yeh , it did reset all settings .,anyways thanks.
doesnt removing the onboard cell and reinserting it do the same thing??
