DIGIT-ARC read-only archive · snapshot: July 23, 2026

Windows 7 fails to boot...plz help!!

18 posts · originally from https://geek.digit.in/community/threads/windows-7-fails-to-boot-plz-help.154347/

T
twinik Original post #1
Mar 19, 2012 at 8:15 PM
Hi,
I'm new to this forum and I need help urgently.
For the past few days my pc stopped to boot properly. whenever I press the power button to switch it on it displays the starting windows logo but nothing happens after that..but when i press the power button again it boots normally. Same thing happens when i hibernate my system.
I thought that it must be a windows problem so I formatted my PC today and installed windows again on a new HDD. but the problem is still there. It was working fine for the past few years without any problem. But suddenly it started. I didn't installed any new software or hardware recntly.
My config is:
AMD Phenom II X4
Gigabyte Motherboard
6 gb RAM DDR2
ASUS sound card installed
2x1 TB HDD
1x2 TB HDD
Corsair 600 W PSU
Windows 7 Ultimate
koolent
koolent #2
Mar 19, 2012 at 11:35 PM
Replug your RAM after cleaning and also clean the ports of your MOBO correctly and thoroughly.. :)
helion
helion #3
Mar 20, 2012 at 12:55 AM
Looks like a PSU issue. Get it checked.
Desmond
Desmond #4
Mar 20, 2012 at 1:18 AM
Run it in safe mode. When the OS boots, look at all the drivers loading and see if it freezes anywhere. Give the name of the .sys file where it freezes.
Posted via Mobile Device
Sujeet
Sujeet #5
Mar 20, 2012 at 11:21 AM
Clear CMOS. And reboot.
Zangetsu
Mar 20, 2012 at 4:51 PM
Clean RAM,
Check PSU,
Scan HDD for any bad sector
doomgiver
Mar 20, 2012 at 4:57 PM
Looks like a PSU issue. Get it checked.

the psu is corsair, i dont think any corsair unit should be causing this sort of troubles
helion
helion #8
Mar 20, 2012 at 5:30 PM
the psu is corsair, i dont think any corsair unit should be causing this sort of troubles

The trouble mentioned has some indication of the system not putting up with the initial draw of current at boot/return from power saving state. Hence the note about PSU. Some times things just freeze and the system will auto reboot as well.

Corsair units have also been on record giving high pitched sounds from the PSU box, although all else being up to the mark. :D
Pratik Pawar
Mar 20, 2012 at 8:05 PM
^^ ya helion is correct.
dont be so sure abt any PSU, even corsair.
I too had a similar probs.:-D
reg PSU, try dis out..
remove the SATA power cable frm PSU to HDD & join another one, an extra frm da PSU to HDD. now check it.. restart ur PC atleast around 5 times to be sure. :wink:
doomgiver
doomgiver #10
Mar 20, 2012 at 9:37 PM
he has 3 disks,
maybe he shuold get the psu checked after all :)
noted, helion
T
twinik #11
Mar 20, 2012 at 10:00 PM
I've tried pulling out RAMs and cleaning and all...
Unplugged all wires then plugged them again but to no avail..
The pSU is just an year old and I dont think that it should be the culprit..
How to clear the CMOS?
Sujeet
Sujeet #12
Mar 20, 2012 at 11:40 PM
Remove the button cell On motherboard for 5 minutes.
CMOS Will be reset.
Ishu Gupta
Mar 20, 2012 at 11:49 PM
Your board might have the CLRTC jumper. Take it out for 10 secs. Plug it back and done.
T
twinik #14
Mar 21, 2012 at 9:54 AM
Is there any adverse effect of resetting the CMOS...
I mean if i short the reset jumper then would it create any furthur problems if not correct the current one?

Earlier under the system tab the RAM was shown as 3.5 GB as usable out of 6 (not exactly)
Now after reinstalling windows after format it shows only 2.75 GB usbale out of 6 so the system also goes out of memory sometimes...what could be the problem..please suggest somethng asap..thanks
helion
helion #16
Mar 21, 2012 at 10:21 AM
Is there any adverse effect of resetting the CMOS...
I mean if i short the reset jumper then would it create any furthur problems if not correct the current one?

Earlier under the system tab the RAM was shown as 3.5 GB as usable out of 6 (not exactly)
Now after reinstalling windows after format it shows only 2.75 GB usbale out of 6 so the system also goes out of memory sometimes...what could be the problem..please suggest somethng asap..thanks

Resetting CMOS doesn't have any ill effects. Reseat the battery after 5 min that's all. You will need to get into BIOS and make sure all is okay and save & exit.

Available memory also depends on whether your OS is 32 bit or 64 bit.
T
twinik #17
Mar 22, 2012 at 9:17 AM
it was a sheer case of neglegence..problem was solved as soon as i unplugged a multi card reader which was plugged to one of the USB ports. Now everything is back to normal smooth booting and waking up from hibernation...
thanks to all for your help and suggestions...
Sujeet
Sujeet #18
Mar 22, 2012 at 10:41 AM
Thats strange.
Still Your Problem is solved.Congrats.